PDA

View Full Version : Bevels....


LostInTranslation
01-08-2013, 02:34 PM
I will be cutting a lot of bevels on plywood to make boxes.....

It seems that bevels are a challenge with this system. Not all tools can do every job well.

Would it be better to just go old school and make a bevel cut track guide out out of plywood for the bevels?

I am the type person that if I cut into the frame of my pretty new EZ bench, I would be really mad at myself.

jswingchun
01-08-2013, 03:54 PM
There is no EZ way to do bevels. There are a few solutions posted around the forum that make it a little easier. There is supposed to be a new base coming out at some point that will address this, but I haven't been able to get any sort of answer as to when to expect it.