The Track Saw Forum  

Go Back   The Track Saw Forum > Burt

Conversation Between Burt and dvsk
Showing Visitor Messages 1 to 1 of 1
  1. dvsk
    02-18-2017 02:09 AM
    dvsk
    Hi Burt. I am looking at buying an EZ1 with the SSRK. I am wondering if I can use it to make raised panel doors. My panel bit is a 3 1/2 inch bit. I am concerned that the 3 1/2 inch bit is too big to use with the SSRK and I will have to keep using a router table to do it. I would like to switch to the SSRK to route panels. From your experience do you think this is a good idea? Thanks

All times are GMT -3. The time now is 08:01 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.