The Track Saw Forum  

Go Back   The Track Saw Forum > Dino

Conversation Between Dino and dvsk
Showing Visitor Messages 1 to 2 of 2
  1. Dino
    02-20-2017 09:06 PM
    Hi dvsk.
    Forget about safety. Your hands are always away from the spinning bit and blades.
    I think the sssrk with the ez=one is the best combo. Just take it easy and make few passes instead of trying to get it done with one pass.
    When you get comfortable you can remove more wood without the usual issues of the routing table. Use the stops and sliding fences. Trap the wood and nothing can go wrong. By using the track you don't have the tear out or a visit to the emergency room....even if you make a mistake.
    thanks and welcome to ez.
    ycf dino
  2. dvsk
    02-18-2017 01:04 AM
    Hi Dino. I am looking at buying an EZ1 with the SSRK. My panel bit is a 3 1/2 inch bit. I am concerned that the 3 1/2 inch bit is too big to use with the SSRK and I will have to keep using a router table to do it. I would like to switch to the SSRK to route panels. From your experience do you think this is a good idea? Thanks

All times are GMT -3. The time now is 12:09 PM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.