Thread: 20 Bridges....
View Single Post
  #12  
Old 12-21-2017, 07:36 PM
tomp913 tomp913 is offline
 
Join Date: Jul 2013
Posts: 252
Default

Ken,

The SME extrusion is 3/4" high, and the connector extrusion is about 11/32" so there should be enough room underneath the connector for a pan head screw.

The instructions for the B-300 show the top of the bracket flush with the top of the EZ-1 frame, but then shows a "work surface" on top. Assuming 3/4" material, I believe that the SME and bracket would be 3/4" below the top of your bench surface - this question has come up before, maybe a search in the Power Bench forum would confirm this.
Reply With Quote