View Single Post
  #12  
Old 10-07-2015, 09:59 AM
foamx foamx is offline
 
Join Date: Jun 2015
Posts: 10
Default

Quote:
Originally Posted by Dino View Post
If you can post few pic's?
Some times after drilling and before screwing
a spec of saw dust can do the damage.
We need to double check everything because the sane time we have
a new and better extruder.
tx
d.
Dino,

Good to hear from you. Thanks for jumping in. You can get an idea from these. The right side of the extrusion is higher than the table top. All four of the channels in the table have this issue somewhere along their length. It's not much of a difference but it has proven to make square joins difficult. Flat has to be flat and depending on where the workpiece lies it's simply not. The photos show one example as it was the easiest to capture. Several other areas have a more pronounced difference.

Lawrence
Attached Thumbnails
Click image for larger version

Name:	IMG_0046.jpg
Views:	225
Size:	83.4 KB
ID:	6700   Click image for larger version

Name:	IMG_0045.jpg
Views:	210
Size:	76.9 KB
ID:	6701   Click image for larger version

Name:	IMG_0044.jpg
Views:	200
Size:	84.4 KB
ID:	6702   Click image for larger version

Name:	IMG_0034.jpg
Views:	212
Size:	69.2 KB
ID:	6703  

Last edited by foamx; 10-07-2015 at 10:04 AM.
Reply With Quote