Thread: 32 MM System?
View Single Post
Old 07-31-2017, 08:56 AM
kenk kenk is offline
Join Date: Feb 2012
Posts: 304

When plunge routing a row of holes the Traveler Bridge should be locked so the SSRK Rail can't slide left-right. The limit stops on the SSRK are there so that the rows are in the exact same place each time you insert new material, and the sliding rail stops are there so the material is placed in the exact same position.

To be safe I wonder if it would be best to flip the two sides top to bottom to ensure that the distance from the siding rail stops to each set of vertical holes is identical.

The only concern I have at this point is making sure that the holes are the exact same distance from the "bottom" of each side of material. If I didn't flip the material that would be easy, but then the distance of each set of vertical holes to the nearest edge could vary.
Reply With Quote