The Track Saw Forum  

Go Back   The Track Saw Forum > The Track Saw Forum > RipSizer

Reply
 
Thread Tools Search this Thread Display Modes
  #11  
Old 12-15-2018, 09:30 AM
JamesMac JamesMac is offline
 
Join Date: Mar 2016
Location: Texas
Posts: 76
Default

Those are pricey and gorgeous.....

hopefully they will make the next batch to register off of the center rib of all of my EZ track.

Jim
Reply With Quote
  #12  
Old 12-15-2018, 05:30 PM
Dino Dino is offline
Master Carpenter
 
Join Date: Jul 2008
Location: Edison NJ
Posts: 5,212
Default

Quote:
Originally Posted by tomp913 View Post

I still think that the UEG, with some modifications, is the better system for breaking a plywood sheet down, ripping to width first before cross-cutting, but there are cases where it's more advantageous to cross-cut first and then rip to width,.

As an aside, I've never run across a sheet of plywood where the edge was too damaged to make the first cut with the UEG, .
tomp....even on the cross cuts.
use any straight edge to Bring the UEG range in the cutting area.
The Antichip inserts are best on the cross cuts.

I just don't see a need for:
Tracks, connectors, measuring and aligning with parallel guides, repeaters...
Clamping?
Then deal with the aftermath of chipping.
So far, Only few 2 tracksaws that I know have copied the AC-2.
Use the AC-1 that works for right and left CS's.

If the AC-1 goes bad ( after years?) or you have a very expensive plywood to cross cut...re-enforce the insert with any tape.
Instead taping the entire panel, tape the insert. EZ?
The more down pressure... the cleanest the cut.

We are working to find other ways for the brackets.
We may have the answer next week.

there is no reason to have any issues with the UEG.
at least...not fixable issues even with the very first UEG.
we have the dual arms, the cleanest cut possible and the Fin.
If the Fin don't work perfectly...widen the base and move the Fin by 1/64"?
Again. No harm done.
__________________
ycf dino
eurekazone.
Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -3. The time now is 07:42 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.