The Track Saw Forum  

Go Back   The Track Saw Forum > The Track Saw Forum > Power Benches

 
 
Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 11-21-2016, 03:57 PM
kenk kenk is offline
 
Join Date: Feb 2012
Posts: 277
Default

Quote:
Originally Posted by mrstop View Post
... for longer rips of narrow stock ...
Hmmm, feeding stock through a fixed blade sounds either like a table saw (saw on bottom) or a radial arm saw (saw on top).

As Dik mentioned, if you don't have a straight side you can just use a long track (or two or more connected tracks) with the clamps to create a clean straight edge.

After that you can use the EZ Smart Universal Edge Guide ($49) to make repeated cuts of the exact same width.

If you are trying to cut very narrow strips - smaller than allowed with the Universal Edge Guide - then the EZ Smart Clamp System ($80) replaces the typical clamps and allows you to cut VERY narrow strips - fractions of an inch in width. The bolts on the clamps even act as feet - to keep the track level during the cut. You can use a combination square to make sure that the rail is perfectly positioned for the cuts. Use two combination squares with a helper to act as mini repeaters.
Reply With Quote
 

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -3. The time now is 11:15 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.