The Track Saw Forum  

Go Back   The Track Saw Forum > The Track Saw Forum > Guide Rail Systems

Thread Tools Search this Thread Display Modes
Prev Previous Post   Next Post Next
Old 07-30-2017, 10:17 PM
tomp913 tomp913 is offline
Join Date: Jul 2013
Posts: 236
Default Making a Solid ACE

I've toyed with this idea for a while, but didn't like the idea of running some 3/4" thick vinyl through my planer to get the 1/2" thickness to match the track given the mess that it was going to make.

I found some 1/2" (actually 12mm) trim at HD and so had run out of excuses. This material is a little thinner than the track, but I couldn't see that being a problem as long as I could have the one surface flush with the bottom of the track to provide the anti-chip feature - the 12mm thickness should be stiff enough to let the strip lay on the material being cut even without any pressure from the saw base.

I wrote up my procedure, here it is as a .pdf document. The whole process is actually pretty easy, but I did use a table saw and router table in order to make the strips, the challenge will be for somebody to figure out how to do it on an EZ1. Rick?

I'm not sure how durable the vinyl ACE will be long term, but there's always the option of making replacements out of UHMW - although that would be considerably more expensive. I'm hoping though that this is going to give me a nice consistent cut line indication.

Attached Files
File Type: pdf Making a Solid Anti-Chip Strip (ACE).pdf (525.5 KB, 94 views)
Reply With Quote

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -3. The time now is 07:56 AM.

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.