What is needed

[bigjohn1]

Originally Posted by jswingchun

If you don't care that people can't understand you or make sense of some of your posts, then yeah, it's no big deal.


It probably wouldn't kill you to check thinks better all time.

Ok you maybe right I will work harder at it JS, It is a weak spot for me and I
also push the the next key beside the key I should also. I took it to heart I guess and get touchie about it.

[Burt]

Originally Posted by jswingchun

Because better ways to handle the same cuts came up maybe? Like the ripsizer? I don't know about using something similar to the EZ Ripper as a solution for bevel cuts, as was suggested in this thread.

If I understand correctly, the guys want a highly accurate bevel capability for all angles not just the usual 45, 30, 22.5, and 15 degree. I don't see the EZ Ripper as the best format to use.


Burt

[tofu]

so basically these ez ripper was an upside down table saw?

[Mel Beck]

Originally Posted by tofu

so basically these ez ripper was an upside down table saw?

No a tunnel saw.

[jswingchun]

Originally Posted by Burt

If I understand correctly, the guys want a highly accurate bevel capability for all angles not just the usual 45, 30, 22.5, and 15 degree. I don't see the EZ Ripper as the best format to use.


Burt

You understand correctly, and yeah, that's what I thought too.

Like I said earlier, I might devise my own system since there is no timeline on the EZ version.

I'm not saying Dino should have a timeline, since they are difficult to predict and difficult to meet.