Smart Clamp or Track change?

[Jeff Freelove]

Recently, my buddy rec'd his EZSMART Track Saw System 108." It came with 2 clamps and he needed 4, so I loaned him mine.

Come to find out, only 2 of my clamps fit his tracks. My other 2 clamps are too thick to fit the new track.

Anyone else experience this?

[bumpnstump]

Originally Posted by Jeff Freelove

Recently, my buddy rec'd his EZSMART Track Saw System 108." It came with 2 clamps and he needed 4, so I loaned him mine.

Come to find out, only 2 of my clamps fit his tracks. My other 2 clamps are too thick to fit the new track.

Anyone else experience this?

Jeff,
I didn't know they'd changed the track extrusion (?); only times I've had a non-fitting clamp is when the all-thread on the clamp loosens up and begins to protrude a bit past the bottom of the clamp extrusion. It doesn't take much for it to not fit into the track, or, to fit with difficulty. To fix, re-locktite the all-thread and sand off the protruding portion of the all-thread, back to being flush with the bottom of the extrusion.
hth,
Rick

[Jeff Freelove]

It's actually the EZ Connector Extrusions that are the issue.

Now for pictures.

Side by Side connectors

The one on the right is too fat at .3560"

The one on the left is .3455"

Manufacturer's variance, no doubt. Eventually, I may buy more Connector Extrusions to rectify the issue. Maybe I can work a trade for my left over B2B extrusions?